Light Gray Basement Coating in Strawbridge
What we built and how it holds.
Family near Roberts Elementary was finishing their basement and needed a floor that handled humidity without curling tile. We moisture-tested, prepped, and installed a light gray micro-flake polyaspartic system end-to-end.
The job started where every Triumph job starts — with the slab. We diamond-ground the existing concrete to a clean profile, not an acid wash. Cracks, joints, and any spalled edges were chased out, filled, and feathered flush. Moisture readings were taken before any coating went down, because nothing kills a floor faster than putting a topcoat over a slab that’s still breathing water.
For Moorestown, we specified a polyurea base coat keyed deep into the prepared concrete, then layered the decorative finish, and locked it all under a UV-stable polyaspartic topcoat. That system is roughly four times tougher than legacy epoxy, cures fast enough to walk that evening, and shrugs off the salt, hot tires, and freeze-thaw cycles South Jersey throws at it. The result is a floor that looks good on day one — and is still flat, sealed, and bonded ten years from now.
Pinned on the map.
Family near Roberts Elementary was finishing their basement and needed a floor that handled humidity without curling tile. We moisture-tested, prepped, and installed a light gray micro-flake polyaspartic system end-to-end.
Right in the neighborhood.
We’re Salem-based with a 45-minute service radius. Here you’re looking at the area around this install.
Like this floor? Let’s talk about yours.
Tell us about your slab. We’ll come look, walk through honest options, and give you a firm written price.